Sanguinololu V1.3A

Sanguinololu V1.3A

Product name: Sanguinololu V1.3A Product Features · Supports multiple communication configurations. · Supports multiple power configurations · Small design - board is 100mm x 50mm (4" x 2") - barely an inch longer than a business card! · Sanguino clone, Atmel's ATmega644P -...

Chat Now

Product Details

Product name:

Sanguinololu V1.3A


Product Features

· Supports multiple communication configurations.

· Supports multiple power configurations

· Small design - board is 100mm x 50mm (4" x 2") - barely an inch longer than a business 

       card!

· Sanguino clone, Atmel's ATmega644P - ATmega1284 drop-in compatible!


Product Description

Sanguinololu is a low-cost all-in-one electronics solution for Reprap and other CNC devices. It features an onboard Sanguino clone using the ATMEGA644P though a ATMEGA1284 is easily dropped in. Its four axes are powered by Pololu pin compatible stepper drivers. 


The board features a developer friendly expansion port supporting I2C, SPI, UART, as well as a few ADC pins. All 14 expansion pins can be used as GPIO as well. 


Version 1.3a has no software changes - the pin assignments remain the same and your 1.2+ compatible firmware should work here fine. The hardware changes: 

-- Removed the Molex HDD connector in favor of using the voltage regulator - some power supplies give a dirty 5V signal when there is no motherboard load, so its better to just use the power supply's ATX+4 connector and the 5V voltage regulator. 

-- Added a jumper to enable/disable USB auto-reset. This way if you're printing from an SD card using SDSL you can disconnect your USB and reconnect it without interrupting a print. 

-- R7 and R8 are now 100k pull-up resistors that are on the stepper-enable lines. This ensures the stepper motors stay disabled and don't move while uploading new firmware, rebooting, etc. The current limiting resistors for the FTDI are gone. 

-- There is an extra Z-motor header for Prusa Mendel. 


Package List: 

1 x Controller board Sanguinololu V1.3a


Kuongshun Electronic, one of the international well-known manufacturers and suppliers of sanguinololu v1.3a which is situated in China, now has quality products for sale. We are equipped with a group of professional and experienced workers, as well as advanced equipment. You can rest assured to buy discount and low price sanguinololu v1.3a made in China from us and check the pricelist with us.

Previous:Smart Adapter For Sanguinololu V1.3A Next:RUMBA

Inquiry